What is the structure of high temperature steam oven

In the application of textile auxiliary detection device, in order to understand the application of high-temperature steam oven, including the fixed connection between the internal main body of the oven body and the oven plate, the placement plate is provided with a box for fabric placement, and a connector component is placed between the box and the positioning plate, which includes a fixed plate connector component attached to the box, and a contact joint between the fixed slot and the fixed plate, It is used to fix the position of the fixing plate to the main structure of the oven.
The current scheme adopts a new mechanical structure, and establishes an oven placement and connection component. Workers can remove the oven to place or arrange the placement box. Workers can shoot more than one piece at a time, which shortens the time for using fabrics, improves the speed of the general inspection process, and provides a temperature control device to keep the oven including the oven shell. The top of the connected buckle is used to fix the oven, The insulation of the external welding pipe of the oven on the top and bottom surfaces is fixed, and the internal pipe insulation layer is set, and the filter screen is fixedly connected to both sides of the air inlet.
The inside of the filter is rotated and connected by the controller. The left and right sides of the temperature control application are equipped with cooling pipes. The left and right sides of the cooling pipes are fixed with exhaust ports. A heating box is connected to the lower right side of the heating box. The heating pipe is fixed in the heating box. The temperature measurement of a block is connected to the upper and lower sides of the heating pipe. The ball thermal insulation is placed on the left side of the temperature measurement block. The heating pipe is fixed on the baffle, It can be seen that this type of oven has simple structure and practical functions.
During the design of the current oven, it is installed in the center of the cooling fan. The ventilation is equipped with a mixing rod with a mixing blade, and under the right and left mixing of the cooling channel, a passive roller is limited at the bottom of the cooling channel, and a passive piston plug is installed inside the drum. The hot melt cooling oven surface and the oven are cooled by a cooling tank, so as to facilitate the cooling of water through the hot melt temperature with large heat capacity and reduce the temperature at the same time, Cooling air is blown out from the fan.